现代制造工程 ›› 2017, Vol. 446 ›› Issue (11): 29-35.doi: 10.16731/j.cnki.1671-3133.2017.11.006

• 工业流程 • 上一篇    下一篇

基于价值流技术的JL包装生产线优化研究

谭阳波, 戴欧阳, 陈曦   

  1. 桂林电子科技大学信息科技学院,桂林 541004
  • 收稿日期:2016-04-25 出版日期:2017-11-20 发布日期:1900-01-01
  • 作者简介:谭阳波,管理学硕士,讲师,主要研究方向为物流管理、精益生产。 戴欧阳,工程硕士,助教,主要研究方向为物流与供应链管理、基础工业工程和精益生产。 陈曦,工程硕士,助教,主要研究方向为工业工程与质理管理。 E-mail:571605686@qq.com
  • 基金资助:
    广西高校中青年教师基础能力提升项目(KY2016B810)

The optimization of package production line based on value stream technology

Tan Yangbo, Dai Ouyang, Chen Xi   

  1. (Institute of Information Technology,Guilin University of Electronic Technology,Guilin 541004,Guangxi,China
  • Received:2016-04-25 Online:2017-11-20 Published:1900-01-01

摘要: 运用价值流技术对桂林JL有限公司包装生产线存在的人机设置不合理、生产周期冗长,以及生产计划与实际需求不符等问题进行分析。采用价值流图优化包装生产线,同时引入拉动系统对生产进行管控,根据顾客的需求确定生产节拍。在此基础上,遵循精益生产的原则,运用工业工程手法进行分析并执行PDCA循环,通过对比改善前后的方案,改善后方案不仅提高了生产线工效,同时改善了人机利用率,减少了生产浪费。

关键词: 价值流图, 包装生产线, 精益思想

Abstract: The problem of package production line in Guilin JL corporation,such as irrational disposition of staffs and machines,cumbersome production cycle and unconformity of production design and actual requirements,were analyzed by using Value streaming technology.Value stream mapping was adopted to optimize package production line.At the same time,pull system was introduced to control production and manufacturing time was identified according to requirements collected from consumers.On this basis,adopting analyses of industrial engineering and following the principles of lean production,and implemented PDCA cycle,through the comparison of before and after improvement,the plan which enhances not only the efficiency of production lines,but also utilization rate of staffs and machines,the production waste was effectively refrained.

Key words: value stream mapping, package production line, lean thinking

中图分类号: 


版权所有 © 《现代制造工程》编辑部 
地址:北京市东城区东四块玉南街28号 邮编:100061 电话:010-67126028 电子信箱:2645173083@qq.com
本系统由北京玛格泰克科技发展有限公司设计开发 技术支持:support@magtech.com.cn
访问总数:,当日访问:,当前在线: